Digital Watchdog D2365T Instrukcja Instalacji Pobierz pdf (Strona 12)

Duet2 D2600 / Duet3 D2650 Installation Manual – EU-D2600-D2650-INST/A10/v1 - 12



Notes (Contact ID Format):

1. The 4, 5 or 6 digit account number, the Contact ID identifier '18' and the Alarm/Restore

digit ('1' or '3') will precede these codes.

2. The checksum will be calculated and appended to the data.

7.4.3.3 For SIA Format

the string should contain 2-letter SIA event code, plus any partition,

zone or user information, up to a maximum of 8 characters. The SIA restore letters are

programmed into another column.

Examples:

Message SIA data Restore

Test Call Manual RX

Test Call Periodic (Auto) RP

PSTN Line Fail LT1 LR

GSM Line Fail LT2 LR

Input 1 BA01 BR

Input 2 TA01 TR

Input 3 BA03 BR

Input 4 BA04 BR

Notes (SIA Format)

For the SIA restore message, the 2 characters in the Restore column will replace the first 2

characters in the data column to produce the new string. The remaining 6 characters in the

data column will be unchanged.

8. FLT Output Relay

The FLT relay contacts, C, NO and NC are used to provide a ‘fault’ output.

Both the wired and radio paths are continuously monitored. Should both wired and radio paths fail

simultaneously, then the FLT relay will energise and the contact will change over.

Where only one path has been enabled and this fails, then the FLT relay will energise and the contact

will change-over.

9. SMS Output Control

Four open collector outputs may be controlled remotely using SMS. See page 15 for connection and

commands.

Note: For SMS Command table, see Appendix 2.

10. Ringing on PSTN

If incoming ringing is detected on the PSTN line, the Duet will switch the alarm control panel over to

the PSTN line and continue monitoring for the alarm control panel off-hook condition.

When alarm control panel off-hook is detected, the Duet will operate the Line Divert relay to isolate

any associated phones while the panel is in download mode. As soon as the alarm control panel on-

hook is detected, the Line Divert relay will be released and normal operation of the Duet will continue.

11. Ringing on GSM

When incoming ringing is detected on the GSM path, the Duet will answer the call and go into

‘Download’ mode. This will allow remote programming / interrogation of the Duet. See the D2454

Programmer Manual for details. It is also possible to request the Duet to call the D0154 Remote

Server via GPRS for the purposes of remote programming (D0154 is a stand-alone computer program

available from Dycon).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Komentarze do niniejszej Instrukcji

Brak uwag

Digital Watchdog D2365T Instrukcja Instalacji Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kamery ochrony Digital Watchdog D2365T